TM 55-1520-240-23-9
11-70
REMOVE COPILOT’S PITCH AND ROLL CONTROL STICK
11-70
INITIAL SETUP
Applicable Configurations:
All
Tools:
Aircraft Mechanic’s Tool Kit, NSN 5180-00-323-4692
Materials:
None
Personnel Required:
Medium Helicopter Repairer
Equipment Condition:
Battery Connected (Task 1-39)
Electrical Power On
Hydraulic Power On
Copilot’s Seat Fully Aft (Task 2-115)
Control Stick Boot Removed (Task 2-81)
Copilot’s Forward Left Floor Cover Removed (Task
2-81)
1.
Remove two screws (1) from two clamps (2).
Remove cable (3) from clamps. Install clamps
and screws loosely in control assembly (4).
2.
Disconnect connector (5) from receptacle (6) on
structure (7) under control assembly (4).
3.
If applied, remove silicone rubber coating from
cotter pin (8) and nut (9). Remove cotter pin,
nut, washer (10), and clamp (15) from bolt (11)
in socket (12). Disconnect bonding jumper (13)
from bolt and cable (3). Cut ties.
4.
Remove bolt (11) and washer (14), from socket
(12). Remove clamp from cable (3).
5.
Disconnect pitch and roll control stick (16) from
socket (12). Twist and pull stick forward. Remove
stick and cable (3).
6.
Install bolt (11), washer (14), clamp (15), washer
(10), and nut (9) loosely in socket (12).
FOLLOW-ON MAINTENANCE:
None
END OF TASK
11-313
