TM 55-1520-240-23-9
11-43
RIG PILOT’S OR COPILOT’S THRUST CONTROL
(Continued)
11-43
22.
Working through right access (22), torque nut
(30) to 103 inch-pounds.
23.
Remove bolt (27) from bellcrank (28).
24.
Install bolt (27), two washers (25 and 26) and nut
(24) in bellcrank (28).
25.
Torque nut (24) to 30 to 45 inch-pounds. Install
cotter pin (23).
26.
Check bolt (27). Bolt shall not rotate with torque
less than 10 inch-pounds. There shall be no
axial looseness. If bolt rotates or is loose, add
washer under nut and repeat step 24.
11-181
