TM 55-1520-240-23-9
11-34
ARTIFICIAL FEEL FORCES CHECK
(Continued)
11-34
64.
Position control (2) at 5.5 inches measured
between grip (3) and pivot block (4). Remove
tape from switch (1).
Applied force must not be more than
45 pounds; otherwise, damage to
thrust CCDA will occur.
65.
Repeat step 53. Force must be 7 to 20 pounds.
66.
Press switch (1) of control (2). Lower control to
5.5 inches measured between grip (3) and block
(4). Release switch.
67.
Repeat step 54.
68.
Position scale (15) down and parallel to shaft
(27). Apply force down until rod (28) starts
moving. Force must be 7 to 23 pounds.
69.
Remove scale (15) and two straps (24 and 26)
from control (2).
NOTE
If artificial feel is out of limits, refer
to adjustment (Task 11-133) or TM
55-1520-240-T.
INSPECT
FOLLOW-ON MAINTENANCE:
Install closet backup panel (Task 2-2).
Install closet acoustic blanket (Task 2-108).
END OF TASK
11-128
