TM 55-1520-240-23-9
11-278.3
ASSEMBLE ROLL ERECT CUTOUT RELAY ASSEMBLY
11-278.3
INITIAL SETUP
Applicable Configurations:
All
Tools:
Tool Kit, Electronic Equipment TK105/G, NSN
5180-00-610-8177
Contact Insertion/Removal Tool M83723-31-20
Gun Type Electric Heater
Materials:
Heat Shrinkable Tubing (E431)
Personnel Required:
Avionic Navigation and Flight Control Equipment
Repairer
Inspector
NOTE
Procedure is same to assemble No.
1 or No. 2 roll erect cutoff relay
assembly. No. 1 relay assembly is
shown here.
INSTALL TERMINAL STANDOFFS
1.
Position two terminal standoffs (1) on support
(2). Install two screws (3) and washers (4).
2.
Solder four wires (5) to standoffs (1). Remove
tags.
3.
Position diode (6) between standoffs (1). Solder
leads (7) to standoffs.
11-1153