TM 55-1520-240-23-8
10-78
INSTALL AFT TANK FUEL LINES AND ELECTRICAL WIRING
(Continued)
10-78
12.
Remove barrier material and tape from hole (46)
in tank. Clean tape residue from tank. Use dry
cleaning solvent (E162) and clean cloths (E135).
Wear goggles to protect eyes. Wear gloves
(E186).
13.
Position wiring harness (47) inside fuel tank.
Push two terminal ends (48 and 49) of harness
through hole (46) and tape terminal ends to
outside of tank (1). Use tape (E388).
14.
Position wiring harness (47), wiring (31), two
electrical wiring clamps (50 and 51), and hose
clamp (52). Install screw (53), washer (54) and
nut (55).
15.
Position hose (8), wiring (31) hose clamp (56)
and electrical wire clamp (57). Install screw (58),
washer (59), and nut (60).
16.
Position wiring (31), wire clamp (61) and tube
clamp (62). Install screw (63) washer (64) and
nut (65).
17.
Position wire harness connectors (66 and 67) at
approximate final installed location. Position wire
harness (7), electrical wiring (31), two harness
clamps (68) and two electrical wiring clamps
(69). Install two screws (70), washers (71) and
nuts (72).
18.
Position hose (6) and wiring (47) at approximate
final installed location. Position hose clamp (73)
and harness clamp (74). Install screw (75),
washer (76) and nut (77).
10-371
