TM 55-1520-240-23-8
10-77
REMOVE AFT TANK FUEL LINES AND ELECTRICAL WIRING
(Continued)
10-77
Do not puncture or scratch lining
of fuel tank. If lining is broken, fuel
penetrates and activates self-sealing
layers. Activated layers swell and trap
fuel. Activated green spongy material
also contaminates fuel system. This
makes it necessary to replace fuel
tank and flush fuel system.
NOTE
Procedure is same to remove fuel
lines and electrical wiring from No. 1
or No. 2 aft fuel tank. No. 1 (left) aft
tank removal is shown here.
1.
Tag four wires (1, 2, 3 and 4). Remove four
screws (5 and 6) and washers (7 and 8). Remove
four wire terminals (9 and 10). Install four screws
and washers.
2.
Loosen two screws (11). Remove four wires (1,
2, 3, and 4) from two clamps (12).
3.
Remove screw (13), washer (14), and electrical
wire clamp (15) from pump mounting bracket
(16).
4.
Remove screw (17), washer (18), and nut (19)
from electrical wire clamp (20) to tube clamp
(21). Disconnect clamps.
5.
Remove screw (22), washer (23), and electrical
wire clamp (24) from tube mounting bracket (25).
10-365
