TM 55-1520-240-23-8
10-42
INSTALL MAIN TANK FUEL LINES AND ELECTRICAL WIRING
(Continued)
10-42
Dry cleaning solvent (E162) is
flammable and toxic. It can irritate
skin and cause burns. Use only in
well-ventilated area, away from heat
and open flame. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
NOTE
Procedure is same to install No. 1
or No. 2 main tank fuel lines and
electrical wiring. No. 1 (left) main tank
is shown here.
1.
Remove barrier material and tape from forward
access hole (1) and aft access hole (2). Clean
any tape residue from face of tank. Use dry
cleaning solvent (E162) and cloths (E135). Use
goggles for eyes. Wear gloves (E186).
2.
Remove tags and position tube (3) and attached
electrical wires (4) in fuel tank (5). Position four
electrical wire clamps (6) and four tube clamps
(7) against four tank attachment hoses (8).
3.
Install four washers (9) and screws (10).
4.
Remove tags and position two hoses (11) in
fuel tank (5). Position three hose clamps (12)
and three hose clamps (13) against three tank
attachment hoses (14).
5.
Install three washers (15) and screws (16).
6.
Position two hose clamps (17 and 18) and spacer
(19) against tank attachment hose (20).
7.
Install washer (21) and screw (22).
8.
Connect two hose connectors (23).
10-212
