TM 55-1520-240-23-7
9-144
ASSEMBLE POWER STEERING CONTROL BOX (AVIM)
(Continued)
9-144
25.
Position cam housing (36) on plate (64). Install
four screws (65).
26.
Install two light sockets (66 and 67) through plate
(64). Install two washers (68) and nuts (69) on
light sockets.
27.
Install washer (70) on switch (71).
28.
Install switch (71) with tab (72) on washer (70)
positioned in alignment hole (74) in plate (64).
29.
Install washer (75) and nut (76) on switch (71).
30.
Solder four wires (77) to light socket (66). Solder
two wires (78) to light socket (67). Use solder
(E360). Remove tags.
31.
Solder three wires (79) to resistor (46). Use
solder (E360). Remove tags.
32.
Install two jumper wires (80 and 81) and three
wires (82) to switch (71) using six screws (83)
and washers (84). Remove tags.
INSPECT
9-579