TM 55-1520-240-23-7
9-99.5.1
ASSEMBLE HOIST/CARGO HOOK PANEL (AVIM)
(Continued)
9-99.5.1
1.
Position brace (1) on housing (2). Install two
rivets (3).
2.
Position two nut plates (4) and install two rivets
(5).
3.
Install receptacles (6 and 7) and install two jam
nuts (87).
4.
Install two 187 ohm resistors (9), two 154 ohm
resistors (10), eight screws (11), nuts (12),
lockwashers (13), and flat washers (14).
5.
Install two terminal boards (15 and 16), diode
(17), two semiconductors (18), four screws (19),
washers (20), and nuts (21).
NOTE
Wiring diagram is shown in Task
9-99.6.
6.
Remove tags and solder wires (22) as required.
Use solder (E360), heat sink (E195), and tubing
(E431) (TM 55-1500-323-25).
INSPECT
7.
Install insulator (23), two spacers (24), screws
(25), and lockwashers (26) on housing (2).
9-382
