TM 55-1520-240-23-7
9-79
INSTALL LANDING LIGHT
(Continued)
9-79
1.
Clean old sealant from flange (1). Use acetone
(E20) and cloths (E120). Use gloves (E186).
NOTE
With 17 , left landing light has NVG
lamp and lens.
2.
Position light (2) in housing (3). Make sure wiring
harness (4) is aligned with hole (5).
3.
Guide wiring harness (4) through hole (5) in side
of housing (3).
INSPECT
4.
Install four washers (6) and screws (7) in light (2).
5.
Remove tape from seven wires (8). Connect
wires to terminal board (9). Install seven nuts
(10) and washers (11). Remove tags from wires.
6.
Install grommet (11.1). Apply sealant (E336)
around edge of grommet and wiring harness (4).
Use gloves (E186).
9-268