TM 55-1520-240-23-7
9-164.5
ASSEMBLE FUEL PRE-CHECK PANEL
(Continued)
9-164.5
INSTALL TERMINAL BOARD
NOTE
Procedure is similar to install two
terminal boards. Installation of
terminal board TB1 is shown here.
4.
Position terminal board (5).
NOTE
If holes in box are elongated, add
washer under head of screw.
5.
Install four spacers (6), screws (7), washers (8),
and nuts (9).
6.
Connect 10 wires (11). Use a heat sink. Use
solder (E319).
INSTALL FLOODLIGHT
7.
Position light (12). Install two screws (13),
washers (14), and nuts (15).
8.
Connect wire (16). Use solder (E319).
9-662