TM 55-1520-240-23-6
7-163
INSTALL PRESSURE CONTROL MODULE THREE-WAY SOLENOID VALVES
(Continued)
7-163
NOTE
Procedure is same to install ramp
control or wheel brake control valve.
Ramp control valve is shown here.
1.
Install valve (1), three packings (2), and six
retainers (3) in RAMP PWR V port (4). Use
cloths (E135) for spilled fluid.
2.
Lockwire valve (1) with lockwire (E231).
Electrical connectors are to be
tightened to more than 1/16 to 1/8
turn beyond finger-tight during
installation, otherwise they will be
damaged.
3.
Connect connector (5) to valve (1).
INSPECT
FOLLOW-ON MAINTENANCE:
Perform operational check (TM 55-1520-240-T).
Bleed utility hydraulic reservoir (Task 7-335).
Close cargo ramp (TM 55-1520-240-T).
END OF TASK
7-694