TM 55-1520-240-23-6
7-115
ASSEMBLE FLIGHT CONTROL RESERVOIR/COOLER (AVIM)
7-115
INITIAL SETUP
Applicable Configurations:
All
Tools:
Hydraulic Repairer’s Tool Kit, NSN 5180-00-323-4891
Torque Wrench, 5 to 50 Inch-Pounds
Torque Wrench, 30 to 150 Inch-Pounds
Deep Socket, 7/16 Inch
Materials:
Cloths (E120)
Hydraulic Fluid (E199)
Lockwire (E231)
Parts:
Cotter Pins
Preformed Packings
Personnel Required:
Aircraft Pneudraulics Repairer
Inspector
References:
TM 55-1520-240-23P
1.
If strap mount (1 or 2) was removed from
reservoir (3), install as follows:
a.
Slide strap mounts (1 or 2) over timing clamp
(3) and onto reservoir (4).
b.
Align notch in strap mount (1 and 2) with
timing clamp (3).
Too much torque will crack the clamps.
c.
Using the deep socket, alternately tighten nut
on each side of strap mount (1 or 2). Torque
strap mount to 50 to 60 inch-pounds.
2.
Measure length of thread extending through the
nuts on each side of strap mount (1 or 2). Length
shall be 0.75 to 0.95 inch.
3.
Install packing (5) on nipple (6).
4.
Install nipple (6) in reservoir (4).
7-523
