TM 55-1520-240-23-6
7-5
REPAIR PERMASWAGE PLUMBING
(Continued)
7-5
NOTE
Swaging dies make ridges on swaged
fitting. Check after-swage dimensions
between ridges.
33.
Inspect swaged end with appropriate size
go-no-go inspection gage according to illustration
of after-swage dimensions. If gage does not fit,
fitting may be reswaged only once. Repeat steps
27 thru 33.
34.
If swaging operation was done off aircraft,
position and attach separable fitting to
component. Align mating ends and position
union fitting. Torque fitting to its final torque,
making sure fixed portion of fitting is held
stationary.
35.
With union fitting positioned correctly, repeat
steps 24 thru 31 for both ends of fitting.
7-39