REPAIR PERMASWAGE PLUMBING (Continued)

REPAIR PERMASWAGE PLUMBING (Continued) - TM-55-1520-240-23-6_51

REPAIR PERMASWAGE PLUMBING (Continued) - TM-55-1520-240-23-6_53

TM-55-1520-240-23-6 CH-47D Heilcopter Manual
Page Navigation
33

TM 55-1520-240-23-6 7-5 REPAIR PERMASWAGE PLUMBING (Continued) 7-5 SWAGE TUBE 21. Mark tube ends. Use correct marking tool for size of tube to be swaged. When marking with tool D9862, place lip stop against end of tube as shown. Using the slot as a guide, mark the tube in two places 180º apart with marking pen (E271.2). If marking tool D9862 and marking pen (E271.2) are not available, see table for tube insertion band. 22. Position prepared tube within fitting. Align mating ends and position union fitting. Check to see if swaging at separable fitting can be done with it installed on the component. If not, mark fitting and tube so that proper clocking is obtained. Swage fitting off aircraft as follows: 7-36

Privacy Statement
Press Release
Contact