DISASSEMBLE AND INSPECT CARGO DOOR ACTUATOR MOTOR (AVIM)

REMOVE CARGO DOOR MOTOR (ACTUATOR) (Continued)

DISASSEMBLE AND INSPECT CARGO DOOR ACTUATOR MOTOR (AVIM) (Continued)

TM-55-1520-240-23-6 CH-47D Heilcopter Manual
Page Navigation
1071

TM 55-1520-240-23-6 7-286 DISASSEMBLE AND INSPECT CARGO DOOR ACTUATOR MOTOR (AVIM) 7-286 INITIAL SETUP Applicable Configurations: All Tools: Hydraulics Repairer’s Tool Kit, NSN 5180-00-323-4891 Steel Rod, 1/16 Inch X 3 Inches (2) Steel Rod, 1/4 Inch X 3 Inches Vise, Soft Jaw Materials: None Personnel Required: Aircraft Pneudraulics Repairer (2) Inspector Equipment Condition: Off Helicopter Task NOTE During disassembly, all parts shall be inspected for obvious damage (Task 7-1.1). 1. Clamp actuator motor (1) in vise (2). Use soft jaw vise. 2. Insert two 1/16 inch rods (3) through notches in retainer (4) into groove of shaft (5). 3. Turn screw (6) counterclockwise while holding two rods (3). 4. Remove screw (6), washer (7), rods (3), and retainer (4) from shaft (5). 7-1068

Privacy Statement
Press Release
Contact