TM 55-1520-240-23-5
6-36
ASSEMBLE FORWARD TRANSMISSION SUMP
(Continued)
6-36
3.
If cap (4) and housing (5) are joined, push cap
into housing, twist, and pull to remove cap from
housing. Remove packing (6) from cap.
NOTE
If cap and housing are new, cleaning
is not needed.
4.
Clean cap (4) and housing (5) with solvent (E162)
and clean cloths (E120). Wear gloves (E186).
5.
Install packing (7) on housing (5). Install housing
(5) in sump (3). Install three bolts (8) and
washers (9). Torque bolts to 60 inch-pounds.
6.
Lockwire three bolts (8) together. Use lockwire
(E231).
7.
Install packing (6) on cap (4).
8.
Press center of cap (4) in and install cap and
packing (6) in housing (5). Push in cap until
center snaps out flush with outside of housing.
Oil (E254) is a skin irritant. If oil
gets on skin, wash thoroughly. If oil
soaks into clothes, change clothes
immediately.
Oil (E254) gives off fumes that can
cause injury to personnel. Use oil in a
well-ventilated area.
9.
Coat packing (10) and thread of drain valve (11)
with oil (E254). Install packing on valve. Install
valve sump (3). Torque valve to 75 inch-pounds.
10.
Lockwire drain valve (11) to sump (3) with
lockwire (E231).
11.
Turn sump (3) over 180º.
6-118
