TM 55-1520-240-23-3
4-134
REPAIR POWER TURBINE CONTROL LINKAGE ROD
4-134
INITIAL SETUP
Applicable Configurations:
Without 74
Tools:
Airframe Repairer’s Tool Kit, NSN 5180-00-323-4944
Materials:
Antiseize Compound (E75)
Epoxy Primer (E292)
Gloves (E184.1)
Parts:
Rod Ends (2)
Rivets
Personnel Required:
Aircraft Structural Repairer
References:
TM 55-1520-240-23P
Equipment Condition:
Off Helicopter Task
1.
Remove lockwire from two nuts (1 and 2).
2.
Loosen nuts (1 and 2).
3.
Remove rods (3 and 4) from turnbuckle (5).
4.
Drill out two rivets (6). Remove bearings (7) from
rods (3 and 4).
Epoxy primer (E292) is flammable
and toxic. It can irritate skin and
cause burns. Use only with adequate
ventilation, away from heat or open
flame. Avoid contact with skin, eyes,
and clothing. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
5.
Install new bearings (7) on rods (3 and 4). Install
rivets wet. Use epoxy primer (E292). Wear
gloves (E184.1).
6.
Coat thread of replacement rods (3 and 4) with
antiseize compound (E75).
7.
Install rods (3 and 4) in turnbuckle (5).
FOLLOW-ON MAINTENANCE:
None
END OF TASK
4-444
