TM 55-1520-240-23-3
3-12.1
INSTALL AFT LANDING GEAR WHEEL AND TIRE ASSEMBLY
(Continued)
3-12.1
8.
Install wheel (7) on axle (8). Align brake disk (9)
with keys (10) on wheel. Seat wheel on axle.
9.
Check that outboard bearing (2) hangs over edge
of journal (11) on axle (8).
10.
If bearing (2) hangs over journal (11), go to step
11.
11.
If bearing (2) does not hang over edge of journal
(11) add spacer (12) as follows:
a.
Remove bearing (2), wheel (7), and sleeve
bushing (13).
b.
Install spacers one or two (12) between
sleeve bushing (13) and axle (8).
Sealing compound (E350) is
flammable and gives off toxic fumes.
It can irritate skin and cause burns.
Use only in well-ventilated area, away
from heat and open flame. In case
of contact, immediately flush skin
or eyes with water for at least 15
minutes. Get medical attention for
eyes.
c.
Apply sealing compound (E350) to bore of
sleeve bushing (13). Install sleeve bushing
on axle (8) while sealant is still wet. Wear
gloves (E186).
d.
Install wheel (7) on axle (8). Align brake disk
(9) with keys (10) on wheel. Seat wheel on
axle.
e.
Install bearing (2) in bearing cup (5).
3-46