TM 55-1520-240-23-3
4-29
REMOVE FORWARD ENGINE MOUNT ADAPTER
(Continued)
4-29
5.
Remove lockwire from two bolts (14) on two
forward engine mount caps (15). Loosen bolts
and push down to side.
6.
Install sling (16) as follows:
a.
Open access door (17) in engine access
cover (18).
b.
Connect two cables (19) to forward fittings
(20) on engine (21).
c.
Connect cable (22) into aft fitting (23) through
cover (18).
d.
Adjust sling (16) until eye (24) is over center
hole (25) in sling bar (26).
e.
Install pin (27) through bar (26).
7.
Connect hoist (28) to eye (24) of sling (16).
Absorb weight of engine (21) with hoist.
8.
Remove nut (29), two washers (30), bolt (31),
and bushing (32) from aft engine mount (33).
During raising and lowering of
powerplant to adapter, make sure
bearing in aft engine mount link does
not tilt in clevis. If bearing tilts, it will
wedge in clevis, causing damage to
bearing and clevis.
4-159
