INSTALL FORWARD OR AFT CARGO HOOK SOLENOID COVER OR WIRE HARNESS (Continued)

INSTALL FORWARD OR AFT CARGO HOOK SOLENOID COVER OR WIRE HARNESS

INSTALL FORWARD OR AFT CARGO HOOK SOLENOID COVER OR WIRE HARNESS (Continued)

TM-55-1520-240-23-10 UH-1H/V and EH-1H Aircraft Manual
Page Navigation
475

TM 55-1520-240-23-10 16-16 INSTALL FORWARD OR AFT CARGO HOOK SOLENOID COVER OR WIRE HARNESS (Continued) 16-16 NOTE Procedure is same to install solenoid cover or wire harness on forward or aft hook. 1. Install gasket (1) on wire harness (2). 2. Feed wire harness (2) through hole (3) in solenoid cover (4). 3. Install four screws (5) and washers (6). Torque screws to 9 inch-pounds. Lockwire screws. Use lockwire (E227). Sealant (E340.1) can irritate skin and cause burns. Avoid contact with skin, eyes, or clothing. In case of contact, immediately flush skin or eyes with water for at least 15 minutes. Get medical attention for eyes. 3.1. Apply sealant (E340.1) around harness (2) where it comes through cover (4). Wear gloves (E186). 4. Position gasket (7) on cargo hook (8). 5. Remove any tags and connect eight harness wires (9) to modules (10). Use insertion/extraction tool. 6. Route wire harness (2) below modules (10) and tie harness to wires from solenoid protection switch (11). Tie harness and wires with strap (E377) (12). 16-106

Privacy Statement
Press Release
Contact