TM 55-1520-240-23-10
16-14
INSTALL CARGO HOOK LOAD BEAM BUMPER
16-14
INITIAL SETUP
Applicable Configurations:
All
Tools:
Aircraft Mechanic’s Tool Kit, NSN 5180-00-323-4692
Materials:
None
Parts:
Cotter Pin
Personnel Required:
Medium Helicopter Repairer
Inspector
References:
TM 55-1520-240-23P
NOTE
Procedure is same to install bumper
on aft cargo hook.
Bumper must be tight fit. Do not trim
or cut.
1.
Position bumper (1) in cargo hook (2). Use soft
faced hammer.
2.
Install bolt (3), two washers (4), nut (5), and
cotter pin (6).
INSPECT
FOLLOW-ON MAINTENANCE:
Perform operational check of cargo hook (TM
55-1520-240-T).
END OF TASK
16-102
