TM 55-1520-240-23-10
16-10
INSTALL SUPPORT BEAM AND BEARINGS
(Continued)
16-10
Methyl-ethyl-ketone (E244) is
flammable and toxic. It can irritate
skin and cause burns. Use only in
well-ventilated area, away from heat
and open flame. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
4.
If installed, clean jumper (8) and bonding
point on beam (2). Use cloths (E135) and
methyl-ethyl-ketone (E244). Wear gloves
(E184.1).
5.
Install screw (9), washer (10), jumper (8), and
nut (11) on beam (2).
Epoxy primer (E292.1) is flammable
and toxic. It can irritate skin and
cause burns. Use only with adequate
ventilation, away from heat or open
flame. Avoid contact with skin, eyes,
or clothing. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
6.
Apply epoxy primer (E292.1) to bonded area.
INSPECT
FOLLOW-ON MAINTENANCE:
None
END OF TASK
16-94
