TM 55-1520-240-23-10
14-22
INSTALL TACKLE BLOCKS/CABLE BLOCKS (RESCUE MODE)
14-22
INITIAL SETUP
Applicable Configurations:
All
Tools:
None
Materials:
None
Personnel Required:
Medium Helicopter Repairer
References:
Task 14-17
TM 55-1520-240-23P
Aft cable block may have cable cutter
installed. Make sure there is no load
on cable. Serious injury to personnel
or damage to equipment can occur.
NOTE
Procedure is same for all tackle blocks
except aft cable block.
1.
Remove cable block (1) from pocket (2) of
stowage container (3).
2.
Position cable block (1), push in keeper (4), and
install cable block (1).
3.
For an aft cable block, install cable cutter (5), if
required (Task 14-17).
4.
Remove quick-disconnect pin (6) and remove
pulley (7).
5.
Position cable (8) between pulley (7) and cable
block (1).
6.
Position pulley (7) in cable block (1) and install
pin (6).
FOLLOW-ON MAINTENANCE:
None
END OF TASK
14-58
