TM 55-1520-240-23-10
14-9
INSTALL WINCH
(Continued)
14-9
4.
Apply light coat of hydraulic fluid (E197) to two
new washers (4) and packings (5). Coat thread
of two elbows (6).
5.
Install one washer (4) and packing (5) on each
elbow (6).
6.
Install elbows (6), with nuts (7) attached. Point
elbows as shown and tighten nuts.
7.
Install cable guard guide (8). Secure with two
screws (9), four washers (10), and two nuts (11).
INSTALL WINCH
8.
Set winch (12) on heater compartment floor.
Route cable (13) through cable guard (14).
9.
Route cable (13) around pulley (15) and bracket
(16). Move pulley outboard along bracket as
needed for clearance. Pass cable through slot
in bulkhead (17).
10.
Align two washers (18) with holes in pulley (15)
and bracket (16). Install bolt (19) and washer
(20). Install washer (21) and nut (22) by reaching
under structure (23).
11.
Position winch (12) to fit cable (13) into cable
guard (14). Align mounting holes in winch and
floor.
14-33
