TM 55-1520-240-23-1
1-15
REPLACE LOCKED-IN STUD (AVIM)
(Continued)
1-15
NOTE
Procedure is same to replace any
locked-in stud. Typical stud shown
here.
For more information on locked-in
studs, refer to TM 43-0104.
If stud is broken off close to mounting
surface, or if drill with speed below
700 rpm is not available, go to step 9.
REMOVE STUD WITH REMOVAL TOOLS
1.
Cover openings in component housing (1) in
area of stud (2). Use barrier material (E80) and
tape (E388).
2.
Install removal tool (3) in drill or drill press.
NO BREAK - WORK HARDER
For Stud:
Use Tool:
MS51989-104
SM91-16
MS51989-105
SM101-18
MS51989-106
SM111-20
MS51989-107
SM121-22
MS51992B-504-13
B1575
SHF101-9SA(8)A
SM101-18
ST-10045
SM101-18
1-22