INSTALL FORWARD LCT ACTUATOR
Some clearance is required to ensure
that the LCT actuator lower end fitting
(28) is not clamped against the face of
the bushing flange (25).
Check that actuator swivels at lower end fitting
bearing (23). Any measurable clearance
between the actuator anti-rotation lugs (24)
and the bushing flange (25) on the yoke is
acceptable. If there is no clearance, add a thin
washer between the bearing inner race and the
Connect actuator connector (26) to receptacle
Perform rigging check of forward and aft longitudinal
cyclic trim actuators (Task 11-40).
Connect forward rotor pitch links (Task 5-99).
Perform neutral rig check (Task 11-33).
Perform LCT actuator portion of AFCS operational
check (TM 55-1520-240-T).
Close pylon work platforms (Task 2-2).
END OF TASK