TM 55-1520-240-23-9
11-39
THRUST CONTROL TRAVEL CHECKS
(Continued)
11-39
14.
Have helper press and hold TRIGGER (1) of
thrust control (2). Pull control up about 6 inches
then lower control until thrust transfer bellcrank
stop (11) in control closet just touches detent
(12).
15.
Measure and record length Y of piston (10).
16.
Release TRIGGER (1) of control (2).
17.
Check piston (10) lengths X and Y. Subtract Y
from X. Difference must be 7-64 to 5/32 inch.
If more or less, adjust detent (Task 11-109) then
repeat steps 14 thru 17.
FOLLOW-ON MAINTENANCE:
Install closet backup panel (Task 2-2).
Install closet acoustic blanket (Task 2-108).
Close forward and aft work platforms (Task 2-2).
Remove hydraulic power.
Remove electrical power.
END OF TASK
11-154