• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
TEST  THRUST  CONTROL  GRIP - TM-55-1520-240-23-7_949
TEST  THRUST  CONTROL GRIP (Continued) - TM-55-1520-240-23-7_951

TM-55-1520-240-23-7 CH-47D Heilcopter Manual
Page Navigation
  910    911    912    913    914  915  916    917    918    919    920  
TM  55-1520-240-23-7 9-140.6 TEST THRUST CONTROL  GRIP (Continued) 9-140.6 1. Test  six  switches  (1,  2,  3,  4,  5,  and  6)  of  thrust control  grip  (7).   Set  meter  (8)  to  RX1  and connect  meter  to  pins  of  connector  (9)  listed below.   Check  meter  indication. 2. Connect  meter  (7)  between  pin  A  and  shaft (10).  Check  meter  indication.  There  shall  be  no indication. 3. Repeat  step  2  for  pins  B,  C,  D,  E,  F,  G,  H,  J,  K, X,  W,  L,  M,  N,  P,  R,  S,  T,  and  U. SWITCH SWITCH POSITION CONNECTOR  PINS METER  INDICATION ENGINE  BEEP TRIM  NO.  1  (1) RPM  INCREASE A   and  C 0  ohm RPM DECREASE B   and  C 0  ohm Center A  and  C  then  B  and  C None ENGINE  BEEP TRIM  NO.  2  (2) RPM  INCREASE F   and  D 0  ohm RPM DECREASE F   and  E 0  ohm SEARCH  LIGHT  (3) EXTEND X   and  H 0  ohm RETRACT X   and  K 0  ohm L X   and  J 0  ohm R X  and  G 0  ohm Center X  and  G,  then  X  and  H,  then  X and  J,  then  X  and  K None SLT-FIL  (4) ON L  and  W 0  ohm OFF L  and  W None THRUST  CONT  BRAKE TRIGGER  (5) Released M   and  N 0  ohm Released N  and  V None Pressed N  and  V 0  ohm Pressed N  and  M None HUD  CONTROL  SWITCH  (6) BRT P   and  S 0  ohm DCLTR R  and  S 0  ohm DIM T   and  S 0  ohm MODE U  and  S 0  ohm Center P  and  S,  then  R  and  S,  then  T and  S,  then  U  and  S 0  ohm INSPECT 9-565







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.