• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
TEST THRUST CONTROL GRIP - TM-55-1520-240-23-7_946
TEST THRUST CONTROL  GRIP (Continued) - TM-55-1520-240-23-7_948

TM-55-1520-240-23-7 CH-47D Heilcopter Manual
Page Navigation
  907    908    909    910    911  912  913    914    915    916    917  
TM  55-1520-240-23-7 9-140.5 TEST  THRUST  CONTROL GRIP (Continued) 9-140.5 1. Test  five  switches  (1,  2,  3,  4,  and  5)  of  thrust control  grip  (6).   Set  meter  (7)  to  RX1  and connect  meter  to  pins  of  connector  (8)  listed below.   Check  meter  indication. 2. Connect  meter  (7)  between  pin  A  and  shaft (9).   Check  meter  indication.  There  shall  be  no indication. 3. Repeat  step  2  for  pins  B,  C,  D,  E,  F,  G,  H,  J,  K, X,  W,  L,  M,  V,  and  N. SWITCH SWITCH POSITION CONNECTOR  PINS METER  INDICATION ENGINE  BEEP TRIM  NO.  1  (1) RPM INCREASE A  and  C 0  ohm RPM DECREASE B  and  C 0  ohm Center A  and  C  then  B  and  C Inf ENGINE  BEEP TRIM  NO.  2  (2) RPM INCREASE F   and  D 0  ohm RPM DECREASE F  and  E 0  ohm SEARCH  LIGHT  (3) EXTEND X  and  H 0  ohm RETRACT X   and  K 0  ohm L X   and  J 0  ohm R X  and  G 0  ohm Center X  and  G,  then  X  and  H,  then  X and  J,  then  X  and  K Inf SLT-FIL  (4) ON L  and  W 0  ohm OFF L  and  W Inf THRUST  CONT  BRAKE TRIGGER  (5) Released M  and  N 0  ohm Released N  and  V Inf Pressed N  and  V 0  ohm Pressed N  and  M Inf INSPECT 9-562







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.