• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL  OVERHEAD  PANEL
REMOVE  OVERHEAD  PANELS  FROM  PANEL

TM-55-1520-240-23-7 CH-47D Heilcopter Manual
Page Navigation
  660    661    662    663    664  665  666    667    668    669    670  
TM  55-1520-240-23-7 9-98 INSTALL OVERHEAD  PANEL (Continued) 9-98 3. Connect ground  wire (10) to  structure  (11).  Install screw  (12),  three  washers (13),  and  nut  (14). 4. Remove  tape  and  install  wire  (15)  on  terminal (16) using washer (17) and nut (18).  Remove tag. 5. Remove  tape  and  install  two  wires  (19)  on terminal  (20) using  washer (21)  and  nut  (22). Remove  tag. 6. Connect  connector  (23)  to  receptacle  (24). Remove  tag. 7. Connect  connector  (25)  to  receptacle  (26). Remove  tag. 8. Connect  connector  (27)  to  receptacle  (28). Remove  tag. 9. Connect  connector  (29)  to  receptacle  (30). Remove  tag. 10. Connect  connector  (31)  to  receptacle  (32). Remove  tag. 11. Connect  connector  (33)  to  receptacle  (34). Remove  tag. 12. Check  all  wire  bundles  in  the  vicinity  of  the overhead  panel  to  ensure  none  are  chafed.   If chafing  is noted, rewire  the  bundle.  If  rewiring will  not  correct  the  chafing,  apply spiral  wrap, NSN  9390-00-836-8493  or  equivalent,  to  the chafed  area  of  the  bundle.  If  the  insulation  has been  worn  away to  expose  a  conductor, replace affected  components. 13. Pivot  panel  (1) up.  Install two  bolts  (35). INSPECT FOLLOW-ON MAINTENANCE: Perform  operational  check (TM  55-1520-240-T). END  OF  TASK 9-313







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.