TM 55-1520-240-23-7
9-79
INSTALL LANDING LIGHT
(Continued)
9-79
7.
Have helper support housing (3) and connect
ten electrical wires (11) to terminal board (9).
Install washers (12) and nuts (13). Remove tags
from wires.
INSPECT
8.
Install terminal board cover (15).
9.
Apply sealant (E336) to both sides of gasket (16).
Install gasket on flange (1). Use gloves (E186).
10.
Tilt housing (3) to one side and guide it up and
inside structure (17). Make sure lamp (18) is aft.
11.
Connect electrical lead (19) to stud (20). Install
washer (21) and nut (22).
12.
Position housing (3) and align holes with
mounting holes on structure (17).
13.
Position housing (23) and install 32 washers (25)
and screws (24).
FOLLOW-ON MAINTENANCE:
Check operation of landing light (TM 55-1520-240-T).
END OF TASK
9-269