• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
REMOVE  APU  GENERATOR (Continued) - TM-55-1520-240-23-7_493
INSTALL APU  GENERATOR (Continued) - TM-55-1520-240-23-7_495

TM-55-1520-240-23-7 CH-47D Heilcopter Manual
Page Navigation
  459    460    461    462    463  464  465    466    467    468    469  
TM  55-1520-240-23-7 9-34 INSTALL APU  GENERATOR (Continued) 9-34 1. Apply  a  light  coating  of  grease  (E190)  to generator shaft splines  (1). APU generator is heavy and can  injure personnel if  it drops.  Generator must be  held  firmly  and  moved  carefully to  prevent  injury. 2. Install  generator (2) over studs (3) with  nuts  (5), large  terminal board  (4) down.  Rotate  generator clockwise.   Tighten  nuts (5). 3. Position  air  inlet (6) on  generator (2) and  install five  screws  (7). NOTE Top  screw in  air inlet is  omitted. 4. Lockwire  (E231)  screws  (7). 5. Install  screen  (8) and  clamp  (9). 9-109







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.