• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
REMOVE  CRUISE  GUIDE  SIGNAL PROCESSOR
TEST FORWARD OR AFT CYCLIC TRIM INDICATOR

TM-55-1520-240-23-7 CH-47D Heilcopter Manual
Page Navigation
  116    117    118    119    120  121  122    123    124    125    126  
TM  55-1520-240-23-7 8-42 INSTALL  CRUISE  GUIDE  SIGNAL  PROCESSOR 8-42 INITIAL  SETUP Applicable  Configurations: All Tools: Electrical  Repairer’s Tool  Kit, NSN  5180-00-323-4915 Materials: Dry  Cleaning  Solvent  (E162) Cloths  (E120) Gloves  (E186) Personnel  Required: Aircraft  Electrician Inspector References: TM  55-1520-240-23P TM  55-1500-323-25 Dry  cleaning  solvent  (E162)  is combustible  and  toxic.  It  can  irritate skin  and  cause  burns.   Use  only  with adequate  ventilation, away  from  open flame.  In  case  of contact,  immediately flush  skin  or  eyes  with  water  for at  least  15  minutes.   Get  medical attention  for  eyes. 1. Clean  bonding  surfaces of signal  processor  (1). Use  dry  cleaning  solvent (E162), cloth  (E120), and  gloves  (E186). 2. Position  signal  processor  (1). 3. Install  four  screws (2)  and  washers  (3). 4. Connect  three  electrical  connectors  (4,  5,  and 6).   Remove  tags. INSPECT FOLLOW-ON  MAINTENANCE: Close  right  pylon  work  platform  (Task  2-2). Perform  operational  check (TM 55-1520-240-T). END  OF  TASK 8-128







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.