INSPECT ENGINE TRANSMISSION CHIP DETECTOR PLUG
Some fuzz on tip of plug is normal.
Check tip (3) of plug (1) for chips. Remove any
chips and save them for contamination analysis
Dry cleaning solvent (E162) is
flammable and toxic. It may irritate
skin and cause burns. Use only in
well-ventilated area away from heat
and open flame. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
Clean tip (3) with dry cleaning solvent (E162)
and cloths (E120). Wear gloves (E186). Dry tip.
Check magnetism of tip (3). Tip shall lift a 1/4-28
Perform operational check of chip detector plug
(1) (TM 55-1520-240-T).
Install chip detector plug (1) in valve (2). Push
in and turn chip detector plug clockwise to lock
Install engine transmission fairing (Task 4-73).
Install engine air inlet fairing (Task 4-75).
END OF TASK