• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
REPAIR COMBINING TRANSMISSION  OIL COOLER OUTSIDE SURFACE (Continued) - TM-55-1520-240-23-5_643
INSTALL COMBINING TRANSMISSION  OIL COOLER (Continued) - TM-55-1520-240-23-5_645

TM-55-1520-240-23-5 CH-47D Heilcopter Manual
Page Navigation
  608    609    610    611    612  613  614    615    616    617    618  
TM  55-1520-240-23-5 6-188 INSTALL  COMBINING TRANSMISSION  OIL COOLER 6-188 INITIAL  SETUP Applicable  Configurations: All Tools: Aircraft Mechanic’s  Tool  Kit,  NSN  5180-00-323-4692 Torque  Wrench,  30  to  150  Inch-Pounds Open  End  Wrench,  1-1/2  Inch Materials: Oil  (E254) Lockwire  (E231) Parts: Packings Personnel  Required: Medium  Helicopter  Repairer Inspector References: TM  55-1520-240-23P 1. Install  two  oil  transfer  tubes  (1),  with  four packings  (2),  in  sump  cover  (3). NOTE Do  not  tilt  cooler.   Oil  can  spill. 2. Install  cooler  (4)  on  two  transfer  tubes  (1)  and nine  studs  (5).   Press down  firmly to  seat cooler on  tubes. 3. Install  washers  (6)  and  nuts  (7)  at  six  places around  inside  of cooler  (4).  Install  washers and nuts at  three  places  around  outside  of  cooler. Torque  nuts  to  70  inch-pounds. 4. Install  bolts  (8),  washers (9),  and  nuts  (10)  at four  places  around  outside  of cooler  (4).  Torque nuts to  70  inch-pounds. 6-622







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.