TM 55-1520-240-23-5
6-3
REMOVE NO. 2 THRU NO. 6 FORWARD DRIVE SHAFT
(Continued)
6-3
REMOVE MOUNT BOLTS
NOTE
Remove bolt from mount at each side
of adapter assembly in same way.
Right mount shown here.
All shafts must be rotated as a unit to
keep blades in phase.
3.
Rotate shaft (4) to align bolt hole (9) with mount
bushing (10).
4.
Support shaft (11) with pad (12) of cloths (E120)
or barrier material (E80).
5.
Remove nut (13) and washer (14) from bushing
bolt (15). Remove bushing bolt and washer (9)
through bolt hole (9). Use socket and extension.
REMOVE SHAFT
NOTE
All shafts must be rotated as a unit to
keep blades in phase.
6.
Rotate shaft (4) to position two bolt holes in
adapter assemblies (8) at top of shaft.
7.
Remove three bolts (3) and special washers (17)
from each end of shaft (4).
8.
With aid of helper, lift shaft (4) from brackets
(18). Remove shaft.
6-17