• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL WEATHER-PROTECTIVE  COVER
INSTALL  WEATHER-PROTECTIVE  COVER (Continued) - TM-55-1520-240-23-4_803

TM-55-1520-240-23-4 CH-47D Heilcopter Manual
Page Navigation
  771    772    773    774    775  776  777    778    779    780  
TM  55-1520-240-23-4 5-138 INSTALL  WEATHER-PROTECTIVE  COVER (Continued) 5-138 2. Install  weather-protective  cover  (1)  as follows: a. Position  raised  section  (3) of  cover (1) over drive  arms  (4). b. Lower  cover  (1) slowly  guiding  three  pitch links (5)  through  boots (6). NOTE Holes  are  not equally spaced. c. Align  holes  (7) in  cover  (1) with  holes  (8)  in drive  collar  (2). d. Install  8 bolts (9), 8  nuts (10), and  24  washers (11  and  12).   Install  bolts  with  head  (13) up and  one  washer (11) under head.   Torque bolts  to  100 inch-pounds. Sealant  (E336) can  irritate  skin  and cause  burns.  Avoid  contact  with  skin, eyes,  and  clothing.  In  case  of  contact, immediately  flush  skin  or eyes  with water for  at  least  15 minutes.   Get medical  attention  for eyes. NOTE Three  rivets  (formerly  used  for phasing) are  installed  on  the  outer rim of  the  weather-protective  covers.  If the  word  PHASING  is stenciled  on  the cover,  paint  over with  black  lusterless paint  (E215). 3. Apply  sealant  (E336)  at  junction  of  drive  collar (2) and  cover (1).  Wear gloves (E186). 4. For  forward  cover (1) only, install  spacer (14) on drive  shaft  (15).   Then  go  to  step  6. 5-776







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.