• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
REPAIR  COMPOSITE WEATHER-PROTECTIVE COVER  (AVIM) (Continued)
REPAIR  COMPOSITE WEATHER-PROTECTIVE COVER  (AVIM) (Continued) EDGE  DELAMINATION

TM-55-1520-240-23-4 CH-47D Heilcopter Manual
Page Navigation
  751    752    753    754    755  756  757    758    759    760    761  
TM  55-1520-240-23-4 5-137.1 REPAIR COMPOSITE WEATHER-PROTECTIVE  COVER  (AVIM) (Continued) 5-137.1 SURFACE  ABRASION 2. Outline  area  of  damage  (2)  with  circle  or  oblong. Use  pencil compass  and  straightedge. 3. Cut  a  piece  of fiberglass  laminate  (E168.1) (3) large  enough  to  overlap  outline  of  damaged  area (2) by 1.0  inch  in  all  directions. NOTE Do  not  sand  into  glass  fibers. Complete  removal  of  primer  is  not necessary. 4. Remove  finish  down  to  primer  from  an  area around  damage  (2) 1.5 inches  larger  in  all directions than  damage.   Use  abrasive  paper (E8).  Use  cloths (E120) damp with acetone  (E20) as needed  to  soften  finish.  Wear gloves  (E186). 5. Clean  area  of finish  removal  (4).  Use  clean  cloth (E120) damp  with  acetone  (E20).   Wipe  area dry  with  a  clean  cloth.   Repeat  until  there  is  no residue  on  dry  cloth. 6. Prepare  adhesive  mixture.   (Refer to  steps 106 thru  109.)  Apply coat of adhesive  to  area  of finish removal  (4). 7. Remove  protective  film  from  both  sides  of laminate  piece  (3).  Carefully pull  at  right angle  to direction  of  fibers. 8. Apply coat of adhesive  to  underside  of  laminate piece  (3).   Center  piece  over damage  (2) and press  down. 9. Bond  and  cure  repair.  (Refer  to  steps  110  thru 122.) 5-756







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.