• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL PITCH  HOUSING SEALS (Continued)
REMOVE  WEAR  SLEEVE

TM-55-1520-240-23-4 CH-47D Heilcopter Manual
Page Navigation
  129    130    131    132    133  134  135    136    137    138    139  
TM  55-1520-240-23-4 5-25 INSTALL  PITCH  HOUSING SEALS (Continued) 5-25 INSTALL  INBOARD SEAL 8. Position  inboard  seal  (6)  on  drift  (E56)  (7)  with seal  lips  (8)  toward  drift. 9. Apply  adhesive  (E63.1)  or  sealant (E340.3)  all around  seal  seat  (9).  Apply  thin  coat  of  adhesive (E63.1)  or  sealant  (E340.3)  around  outside  of inboard  seal  (6).  Wear  gloves (E184.1). 10. Press  inboard  seal  (6)  into  housing  (1).   Tap lightly with  rawhide  mallet if necessary.  Remove drift  (7). 11. Apply  bead  of  adhesive  (E63.1)  or  sealant (E340.3)  between  inboard  seal  (6)  and  housing (1).   Wear  gloves  (E184.1).   Allow  adhesive  to cure  for  6 hours. Do  not  allow  excess  grease  to  remain on  seals.  Grease  can  plug  oil  holes and  contaminate  bearing  oil. 12. Apply  grease  (E190)  to  seal  lips  (10).   Wipe  off excess  grease. INSPECT FOLLOW-ON  MAINTENANCE: Install  pitch-varying  housing  (Task  5-23). END  OF  TASK 5-136







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.