• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
ADJUST GAS  PRODUCER  CONTROL SYSTEM (Continued) - TM-55-1520-240-23-3_622
ADJUST GAS  PRODUCER  CONTROL SYSTEM (Continued) - TM-55-1520-240-23-3_624

TM-55-1520-240-23-3 CH-47D Heilcopter Manual
Page Navigation
  583    584    585    586    587  588  589    590    591    592    593  
TM  55-1520-240-23-3 4-102.1 ADJUST GAS  PRODUCER  CONTROL SYSTEM (Continued) 4-102.1 Do  not  adjust  locknut  on  N1  control box. 12. If  the  index  mark  (6)  on  pointer  (4)  is  not approximately  centered  on  EMER  band  (9)  and pointer  is  not  in  contact  with  mechanical  stop (8),  adjust  resistor  shaft  (15)  until  index  mark (6)  on  pointer  (4)  is  approximately  centered  on EMER  band  (9)  and  pointer  is  in  contact  with mechanical  stop  (8). NOTE Turning  resistor  shaft  clockwise will  cause  pointer  to  move  toward mechanical  stop.   Counterclockwise adjustment  will cause  pointer  to  move away  from  mechanical  stop. 13. If  dark  band  (11)  on  rod  (10)  is  not  partially covered  (as  illustrated),  adjust  resistor  shaft  (15) until  dark  band  (11)  is  partially  covered. NOTE Turning  resistor  shaft  clockwise will  tend  to  cover  band  (11). Counterclockwise  adjustment  will tend to  uncover  band  (11). 14. Have  helper  check  pointer  (4)  on  fuel control  (5). Make  sure  index  mark  (6)  on  pointer  is  centered on  EMEG  band  (9).   If  so,  go  to  step  15.  If  not, repeat  steps  12,  13,  and  14. NOTE If  proper  adjustment  cannot  be obtained  and  gas  producer  control box  has  been  changed,  refer  to  TM 55-2840-254-23. 15. Make  sure  band  (11)  on  rod  (10)  is  partially covered.  If  so,  go  to  step  16.  If  not,  repeat  steps 12,  13,  and  14. 4-385







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.