• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
ADJUST GAS  PRODUCER  CONTROL SYSTEM (Continued) - TM-55-1520-240-23-3_620
ADJUST GAS  PRODUCER  CONTROL SYSTEM (Continued) - TM-55-1520-240-23-3_622

TM-55-1520-240-23-3 CH-47D Heilcopter Manual
Page Navigation
  581    582    583    584    585  586  587    588    589    590    591  
TM  55-1520-240-23-3 4-102.1 ADJUST GAS  PRODUCER  CONTROL SYSTEM (Continued) 4-102.1 Do  not  adjust locknut  on  N1  control box. 9. Adjust  resistor  shaft  (14)  until  index  mark  (6) on  pointer  (4) is  approximately  centered  on OFF  band  (7)  and  pointer  is  in  contact  with mechanical  stop  (8). NOTE Turning  resistor  shaft  clockwise  will cause  pointer to  move  away from  the stop.   Counterclockwise  adjustment will cause pointer to move toward stop. 10. Have  helper check  pointer (4)  on  fuel  control (5).   Make  sure  index  mark  (6)  on  pointer is approximately  centered  on  OFF  band  (7) and pointer is  in  contact  with  mechanical  stop  (8).  If so, go  to  step  15.  If not, repeat steps  9  and  10. 4-383







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.