• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
REMOVE  ENGINE  COVER  FORMER (Continued)
INSTALL ENGINE  COVER  FORMER (Continued)

TM-55-1520-240-23-3 CH-47D Heilcopter Manual
Page Navigation
  447    448    449    450    451  452  453    454    455    456    457  
TM  55-1520-240-23-3 4-46 INSTALL  ENGINE  COVER  FORMER 4-46 INITIAL  SETUP Applicable  Configurations: All Tools: Powerplant  Repairer’s   Tool  Kit,   NSN 5180-00-323-4944 Materials: None Personnel  Required: Aircraft  Powerplant  Repairer Inspector References: TM  55-1520-240-23P Do  not  pinch,  crush,  kink,  or  make sharp  bends in  element.  Element can be  damaged. NOTE Procedure  is  same  to  install  engine cover  former  on  No.   1  or  No.   2 powerplant.   Installation  of  No.   1 former is  shown  here. 1. Position  former (1) and  retaining  rings (2  and  3) on  powerplant  (4)  so  that  bolt  holes in  former rings and  powerplant align.  Install  16  bolts (5), 2 washers (6), and  14  washers (7) in  top  of  former (1). NOTE Do  not  tighten  bolts at this time. 2. Install  5  screws  (8),  washer (6), and  4  washers (9)  in  bottom  of  former  (1). NOTE Do  not  tighten  bolts at this time. 4-240







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.