TM 55-1520-240-23-3
4-42
REPAIR CONNECTING LINK (DRAG STRUT) AND ENGINE MOUNT FITTINGS
(AVIM)
(Continued)
4-42
8.
Apply epoxy primer (E292) to outside of race
(18), inside of bushing (11), and hole in fitting (9).
Allow primer to dry. Wear gloves (E184.1).
9.
Brush outside of race (18) and inside of bushing
(11) with sealant (E328). Wear gloves (E184.1).
10.
Install bearing (8) in bushing (11).
11.
Position link (3) on aft engine mount fitting (9).
Align holes in lower end of link (3), bearing (19),
and fitting. Mark position of bushing (11) with
chalk (E110).
12.
Brush outside of bushing (11) and hole (10) in
fitting (9) with sealant (E328).
13.
Align bushing (11) with mark on fitting (9) found
in step 11. Install bushing in fitting.
14.
Stake fitting (9). Use staking tool (51) (T109).
INSPECT
15.
Go to step 20.
4-231