TM 55-1520-240-23-10
16-6
INSPECT CENTER CARGO HOOK PARTS AVIM
(Continued)
16-6
14.
Inspect two bushings (16). Teflon liner shall not
be torn or worn through.
15.
Measure two bores (17) in block (18). Diameter
shall not be more than 1.188 inches.
16.
Measure inside diameter of six bushings (19).
Diameter shall not be more than 0.502 inch.
17.
Measure width of block (18). Width shall not be
less than 4.995 inches.
18.
Measure diameter of bolts (20). Diameter shall
not be less than 0.499 inch.
19.
Inspect bearings (21) (TM 55-1500-322-24).
20.
Inspect shaft (22). Shaft shall not be bent.
21.
Measure diameter of bearing surfaces of shaft
(22). Diameter shall not be less than 0.749 inch.
22.
Inspect two cams (23). Corners of cams shall not
be rounded.
23.
Measure inside and outside diameter of spacer
(24). Inspect spacer (24) for evidence of
excessive wear. Nominal dimension of spacer is
3.750 inches in length, 0.277 inch ID and 0.375
inch OD.
16-49