• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
INSTALL WINDSHIELD WIPER BLADE
ADJUST WIPER ARM PRESSURE

TM-55-1520-240-23-10 UH-1H/V and EH-1H Aircraft Manual
Page Navigation
  72    73    74    75    76  77  78    79    80    81    82  
TM 55-1520-240-23-10 12-36 INSTALL WINDSHIELD WIPER BLADE     (Continued) 12-36 1. Check disk (1).  There shall be no stripped grooves. 2. Install disk (1) on end of arm (2). 3. Install small nut (3). 4. Check wiper blade (4).   There shall be no cracked, torn, or loose rubber. 5. Insert stud (5) of wiper blade (4) through disk (1) and arm (2). 6. Align wiper blade (4) with arm (2).  Be sure air scoop (6) is facing outboard. 7. Install washer (7), nut (8), and cotter pin (9). 8. Remove protective paper and tape from windshield (10). 9. Remove cotter pin (11) from hole (12). 10. Lower arm (2) so blade (4) is on windshield (10). INSPECT FOLLOW-ON MAINTENANCE: Adjust wiper arm pressure (Task 12-37). END OF TASK 12-86 Change 1







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.