• Home
  • Download PDF
  • Order CD-ROM
  • Order in Print
WINDSHIELD  WIPER  SYSTEM
INSTALL WINDSHIELD WIPER BLADE

TM-55-1520-240-23-10 UH-1H/V and EH-1H Aircraft Manual
Page Navigation
  70    71    72    73    74  75  76    77    78    79    80  
TM  55-1520-240-23-10 12-35 REMOVE  WINDSHIELD WIPER  BLADE 12-35 INITIAL  SETUP Applicable  Configurations: All Tools: Aircraft Mechanic’s  Tool  Kit,  NSN  5180-00-323-4692 Workstand Cotter  Pin,  1/8  Inch  Diameter Materials: Masking  Tape  (E388) Wrapping  Paper  (E263) Personnel  Required: Medium  Helicopter  Repairer Equipment  Condition: Battery Disconnected  (Task  1-39) Electrical  Power  Off Windshields  can  be  damaged  while wipers are  being  worked  on.  Failure to  protect  it can  result  in  damage  to windshield. NOTE There  are  two  windshield  wipers. Removal  procedure  is same  for  both. Right  wiper  is shown  here. 1. Lift  wiper  arm (1)  and  insert cotter  pin  (2)  in  hole (3)  in  arm. 2. Cover  windshield  (4)  with  paper  (E263).   Use tape  (E388)  to  hold  paper  on  windshield. 3. Remove  cotter  pin  (5), nut  (6), and  washer  (7). 4. Remove  small  nut  (8). 5. Remove  wiper  blade  (9)  and  disk (10)  from  wiper arm  (1). FOLLOW-ON  MAINTENANCE: None END  OF  TASK 12-84







Western Governors University

Privacy Statement
Press Release
Contact

© Copyright Integrated Publishing, Inc.. All Rights Reserved. Design by Strategico.