TM 55-1520-240-23-8
10-54
INSTALL MAIN FUEL TANK AFT BOOST PUMP AND CHECK VALVE
(Continued)
10-54
INSTALL TANK AFT ACCESS DOOR
9.
Position gasket (18) and access door (19) next to
access hole in tank (6).
NOTE
Coat preformed packings with
petrolatum (E274).
10.
Position electrical cable (20). Insert receptacle
(21) through hole (22). Check that packing
is installed on receptacle. Install keywasher
(23.1). Install and hand tighten locknut (23) on
receptacle.
11.
Position electrical cable (24). Insert receptacle
(25) through hole (26). Check that packing is
installed on receptacle. Install and hand tighten
locknut (27) on receptacle.
12.
Remove plug from ring nut (28) and cap from
hose (29). Connect hose to ring nut. Tighten
ring nut with a strap wrench until it is bottomed
against hose fitting. Check that ring nut fits
against hose fitting with a gap of no more than
0.050 inch.
Incorrect connection of fuel and vent
hoses will not be evident during
gravity refueling, only during pressure
refueling. Airframe damage will occur.
13.
Remove tag and plug from vent hose (30) and
cap from fitting (31). Connect hose to fitting.
14.
Remove tag and plug from fuel hose (32) and
cap from fitting (33). Connect hose to fitting.
10-266
