TM 55-1520-240-23-8
10-52
INSTALL MAIN FUEL TANK FORWARD BOOST PUMP AND CHECK VALVE
(Continued)
10-52
Dry cleaning solvent (E162) is
flammable and toxic. It can irritate
skin and cause burns. Use only in
well-ventilated area, away from heat
and open flame. In case of contact,
immediately flush skin or eyes with
water for at least 15 minutes. Get
medical attention for eyes.
7.
Remove barrier material and tape from access
hole in tank (9). Clean tape residue from tank.
Use dry cleaning solvent (E162) and cloths
(E120). Wear goggles to protect eyes. Wear
gloves (E186).
Do not puncture or scratch lining
of fuel tank. If lining is broken, fuel
penetrate and activates self-sealing
layers. Activated layers swell and trap
fuel. Activated green spongy material
also contaminates fuel system. This
makes it necessary to replace fuel
tank and flush fuel system.
8.
Position boost pump (8) on bracket (10). Install
four bolts (11) and washers (12).
9.
Position spacer (13) and cable clamp (14). Install
bolt (15), washer (16), and nut (17).
10.
Remove caps from boost pump (8) and plugs
and tags from hoses (18 and 19). Connect hoses
to pump. Torque hose connector (19) to 1125
inch-pounds.
11.
Connect electrical connector (20) to boost pump
(8). Remove tag. Lockwire connector to pump.
Use lockwire (E231).
10-256
