TM 55-1520-240-23-7
9-140.3
ASSEMBLE THRUST CONTROL GRIP
(Continued)
9-140.3
5.
Remove tape, solder three wires (16) to switch
(17). Use solder (E360). Remove tags.
6.
Position switch assembly (18) in thrust control
grip (19). Install pin (20).
7.
Remove tape, solder five wires (21) to switches
(1 and 2). Use solder (E360). Remove tags.
8.
Remove tape, solder two wires (22) to switch (3).
Use solder (E360). Remove tags.
9.
Remove tape, solder five wires (23) to switch (6).
Use solder (E360). Remove tags.
10.
Remove tape, solder five wires (24) to switch
(11). Use solder (E360). Remove tags.
Varnish (E435) is flammable and toxic.
It can irritate skin and cause burns.
Use only with adequate ventilation,
away from heat or open flame. Avoid
contact with skin, eyes, or clothing.
In case of contact, immediately flush
skin or eyes with water for at least
15 minutes. Get medical attention
for eyes.
11.
Apply varnish (E435) to all soldered joints. Wear
gloves (E186).
INSPECT
12.
Position switch panel (5) on grip (19). Install five
screws (25).
FOLLOW-ON MAINTENANCE:
None
END OF TASK
9-557
